Publicidad
Idiomas disponibles
Idiomas disponibles
OPERATION
The fan heater can be operated using the
manual controls located on the fan heater.
Carefully remove the fan heater from the
box and bag.
Make sure the appliance is in the off position
(o) before connecting the fan heater to the
mains.
The fan heater must be placed on a solid,
flat surface.
Plug the power plug into an electrical
outlet. Make sure the plug is securely in
the socket. If not properly seated, it can
overheat and damage the outlet. The cord
and plug assembly may become hot during
normal use.
Turn the Power & Mode rotary knob to the
desired programmed temperature. The low
temperature (1000W) is represented by ( I )
and the high temperature (2000W) by ( II ).
For fan only operation without any heat
production, turn the Power & Mode rotary
knob to the fan setting ( ).
To adjust the temperature, adjust the
thermostat adjustment knob, depending
on the room temperature and the desired
temperature. The appliance only starts up
after turning the thermostat adjustment
knob to a temperature higher than that
measured by the appliance's internal
thermostat.
To turn off the fan heater, turn the Power
& Mode rotary knob to the off position (o).
Then remove the plug from the socket.
The indicator light remains on until the
appliance is turned off.
THERMOSTAT INSTRUCTIONS
Before adjusting the thermostat, let the fan
heater operate and heat the room. To do
this, turn the thermostat adjustment knob
to the maximum temperature.
When the desired temperature is reached,
lower the thermostat setting until the fan
heater switches off. You can do this by
turning the thermostat adjustment knob
counterclockwise.
The fan heater will automatically maintain
the set temperature by cycling on and off.
To prevent the fan heater from cycling on
and off, set the thermostat adjustment
knob to a higher temperature position.
NOTE: It is normal for the fan heater to
turn on and off as it maintains a fixed
temperature.
SAFETY FEATURES
Fall protection system:
The appliance has a safety device that
switches it off automatically if the working
position is not correct or if the appliance
falls over.
The fan heater is equipped with thermal
overload protection to prevent overheating.
The fan heater switches off automatically
when it reaches an excessive temperature.
It only works again if the user restarts the
appliance. (See RESTART INSTRUCTIONS
below)
RESTART INSTRUCTIONS
Turn off the fan heater and wait 15 minutes
for the appliance to cool down.
After 15 minutes, turn the appliance back
on and operate normally.
English
17
Publicidad
