Dantherm Master BC 80 Manual De Instrucciones página 9

►1.23. The water used to fill the cooler
tank must come from an aqueduct.
If it is not possible to draw from an
aqueduct, the water introduced must
be subjected to a sanitation treat-
ment, according to European Direc-
tive 98/83/EC.
-We recommend using water with a
hardness of less than 15°f.
-The cooler tank must be emptied
and sanitised periodically depending
on the use.
-The cooling pad surfaces must be
periodically inspected and sanitised
depending on the use.
-For sanitation operations, biocidal
products that comply with European
regulation no. 582/2012 must be used.
►►2. UNPACKING
►2.1. Remove all packaging materials
used to wrap and deliver the appliance
and dispose of them in compliance with
the Standards in force.
►2.2. Extract all items from the packaging.
►2.3. Verify if damage undergone during
transport. If the appliance appears
damaged, inform the dealer, where the
purchase was made, immediately.
►►3. ASSEMBLY
The device is equipped with wheels to
facilitate handling. Depending on the
model, wheels can be found already
installed or not. Components equipped
with relative nuts and bolts are found
inside the packaging (Fig. 1).
►►4. OPERATION
WARNING: Thoroughly read the
"INFORMATION
SAFETY", before switching the
appliance on.
WARNING: Only use clean water to
prevent failures or other anomalies.
Figures and texts of this book are protected by COPYRIGHT.
REGARDING
WARNING: Verify if your electronic
system is earthed
Connection to the mains must
be made in compliance with the
National Standards in force. Power
the appliance only with voltage and
frequency as specified on the data
plate.
NOTE: These
connected to the water mains, by
connecting the pipe to the fitting
(Fig. 10).
►►4.1. SWITCHING ON:
►4.1.1. Open the tank door (Fig. 2).
►4.1.2. Fill the tank with water (Fig. 3);
water level must be within MIN and MAX
level of the graduated scale, placed
at the side of the appliance (Fig. 4), in
order to prevent risks.
►4.1.3. Close the tank door (Fig. 5).
►4.1.4. Connect the power plug to the
mains (Fig. 6).
CAUTION: When the supply plug is
connected to the power mains, the
display shows the approximate room
temperature.
►4.1.5. Press the ON/OFF button to
switch on the appliance (Fig. 9).
►►4.2. CONTROL PANEL, USE
AND FUNCTIONS (Fig. 7-8):
►ON/OFF: It allows switching ON or OFF
the appliance.
►SPEED: Allows increasing or decreasing
the appliance ventilation speed. Three
speeds can be selected - LOW, MID and
HIGH.
►COOL: It enables or disables the cooling
mode.
►SWING: It enables or disables the
automatic vertical oscillation of the flaps
to direct the air flow.
►ANION: It enables or disables the
ionisation mode, i.e. release of negative
ions into the environment, in order to
make air healthier.
correctly.
models can be
en