Trust START-LINE APIR-2150 Manual De Instrucciones página 7

APIR-2150 WIRELESS MOTION SENSOR
EN
1. Open sensor housing
Remove the screws to open the battery compartment.
2. Install transmitter batteries
Place 2x 1,5V AAA alkaline batteries in the battery compartments. The polarity should match the
symbols on the holder.
3. Assign code to a Trust Smart Home receiver
Program the code of this transmitter into the memory of one or several Trust Smart Home receivers.
Slide the LEARN switch from [DEL] to [SET] to send an ON-signal. Read the receiver's manual for the
code learning procedure.
4. Code confirmation
Slide the LEARN switch back to DEL and after a short pause slide the LEARN switch to SET again. The
connected light or chime will react. If not, repeat the previous step.
5. Set switch-off delay
When no more motion is detected, the transmitter automatically sends an OFF-signal after 5 seconds
or 1/5/10 minutes.
6. Set light sensitivity
R
Slide the [ ] switch to select 1 of the 3 light sensitivity levels. [H]: Sensor is always active. [M]: Sensor
is active when the environment brightness is less than 20 lux (late afternoon). [L]: Sensor is active
when the environment brightness is less than 10 lux (late evening). If you want to control a chime,
always choose [H].
7. Close sensor housing
Tighten all screws to ensure waterproofness.
1