RuarkAudio BackPack 3 Guia Del Usuario página 5

Fitting BackPack 3
Unplug the mains adapter (3)
from your Ruark radio or speaker,
position BackPack 3 on the back
of your radio or speaker pushing
the DC output connector (4)
into the 14V DC socket (5).
Secure BackPack 3 with the
two fixing screws (2) using
the Allen key (1) taking care
not to overtighten them.
Connect the mains adapter (3)
to the DC input socket (6) on
the underside of BackPack 3.
Charging BackPack 3
BackPack 3 charges whenever it
is connected to 14V DC power.
The green LED (7) on the back
will illuminate during charge and
turn off when fully charged.
If your BackPack 3 does not
charge or the LED (7) flashes,
contact your dealer.
Note: BackPack 3 is optimised
to work with R1 mk4. For
hints and tips on using it with
R1 mk2/mk3 or MR1mk1/mk2,
see www.ruarkaudio.com/support
Power reset
To restart or cold boot your radio
or speaker with a BackPack 3 fitted,
first turn your radio or speaker
on, then insert a paperclip or sim
removal tool into the small hole (8)
and press and hold the reset switch
for about 3s. Your radio or speaker
will then boot up again as normal.
EN
DA
DE
ES
FR
IT
JA
KO
NL
NO
RU