Owner's Manual |
Fuel | 20 lb. Propane Tank
!
WA r n I n G
If "growing" bubbles
appear during leak test,
do not use or move the LP
bottle. Immediately contact
an LP gas supplier or
fire department.
!
C A U T I o n
Do noT USE HoUSEHoLD
CLEAnInG AGEnTS.
Damage to gas valve, hose,
and regulator compo-
nents may result.
FIGURE 01
FIGURE 02
16
Section 03
LEAK TEST INSTRUCTIONS
LEAK TEST SAFE T Y
• Leak test must be repeated
each time LP tank is exchanged
or refilled.
• Do not smoke during leak test.
• Do not use an open flame to check
for gas leaks.
• Appliance must be leak tested
outdoors in a well-ventilated
area, away from ignition sources
such as gas fired or elec-
trical appliances.
• During leak test, keep appliance
away from open flames or sparks.
LEAK TEST: TANK
S T E P 0 1
Use a clean paint-
brush and a 10/90 mild soap and
water solution.
S T E P 0 2
Brush soapy solution
onto joint areas of tank. (Indicated
by arrows in figure 01.)
Leaks are indicated by
growing bubbles.
LEAK TEST: VALVES,
HOSE & REGUL ATOR
S T E P 0 1
Turn all griddle control
knobs OFF.
S T E P 0 2
Be sure regulator is
tightly connected to LP tank.
S T E P 0 3
Completely open LP
tank valve by turning OPD hand
wheel counterclockwise.
If you hear a rushing sound,
turn gas off immediately. There
is a major leak at the connection.
Correct before proceeding.
Please visit blackstoneproducts.
com/support for customer support
and replacement parts.
S T E P 0 4
Brush soapy solution
onto areas where bubbles are shown
in figure 02.
If "growing" bubbles appear, there
is a leak. Close LP tank valve imme-
diately and re-tighten connections.
If leaks cannot be stopped DO NOT
TRY TO REPAIR.
Please visit blackstoneproducts.
com/support for customer support
and replacement parts.
S T E P 0 5
Always close LP bottle
valve after performing leak test by
turning hand wheel clockwise.
Model 1554