Genie 580 XCD Plus Manual Del Usuario página 12

Under the above conditions, the automatic overload protection for the motor is triggered and
the power supply to the device is interrupted. In such cases, the "Power/Overheat" LED lights
up red. Take the following measures:
1. Unplug the power cord from the AC outlet to allow shredder to cool down. Tear or cut off
any excess paper from the top of the shredder.
2. Connect the power plug to the AC power socket again. Wait until the "Power/Overheat"
LED lights up green. Set the switch to its REV position. Pull the remaining paper away from
the cutting blades. Then set the switch back to its AUTO position. Repeat this process, if
necessary.
With the Main Switch in the AUTO position and the feed opening clear, you are now ready
3.
to resume normal shredding.
Cleaning
Warning! The blades of the device are very sharp! Danger of injury!
1. Switch off the unit.
2. Disconnect the power plug from the power socket.
3. Empty the drip trays regularly.
4. Clean the surface of the housing with a soft, dry, lint-free cloth. Do not use any solvents or
cleaning agents.
Remove any residue in the cutting holes with a suitable object.
5.
Specifications
Shred type:
Shred Size:
Shredding Capacity:
Feed Opening:
Feed Opening for CD/DVDs:
Input:
Shredding speed:
Basket capacity:
We declare that this device, with regard to its task of the destruction of documents, fulfils the
conditions defined for Security Level P-4 in accordance with DIN 66399.
P-4: Recommended for data media containing particularly sensitive and confidential data.
Material particle area ≤ 160 mm² and for consistent particles: strip width ≤ 6 mm (e.g. particles
4 x 40 mm).
Cross cut
5 x 18 mm
10 Sheets
220mm for paper
120mm
220-240 volt AC, 50HZ,1.2A
1.6 m/min
21 L
- 12
-