Publicidad
Idiomas disponibles
Idiomas disponibles
• You will see the
icon blinking on the display. This confirms that
the radio is in Easy Pairing mode waiting to receive the Channel
and Sub-Code settings from the Leader's radio. All Members'
radios will remain in this mode for 3 minutes.
• A group with many radios should have all users take this step at
the same time, so all radios can be programmed in one go.
3. On the Leader's radio, press and hold down the button
until you hear a double beep.
Note:
• At the double beep, this radio's Channel and Sub-Code settings
will be transmitted, which will be received and copied by all the
other (Members') radios.
• The Leader's radio must make this transmission when all the
Members' radios are still in the Easy Pairing mode, otherwise the
transmission will not be picked up.
• On the Leader's radio, user must remember not to release the
button on the first (single) beep, otherwise this radio will become
another Member's radio. If that happens, you can press PTT to
escape, and retry the steps described in #3 again.
• If the Leader's radio is set to a channel between 9 and 16,
please ensure that all Members' radios have channels 9 to 16
activated.
• When a Member's radio with only eight Channels is being Easy-
Paired by a Leader's radio on Channel 9 or above, Easy-Pairing
will fail, indicated by three short beeps, and "Err" is displayed
briefly.
Internal Voice Operated Transmission/
Voice Operated Transmission (
Transmission is initiated by speaking into the microphone of
the radio/audio accessory instead of pushing the PTT
button.
L3 = High Sensitivity for quiet environments
L2 = Medium Sensitivity for most environments
L1 = Low Sensitivity for noisy environments
1. Press
Menu until the
display. When audio accessory is connected, the
icon will be shown. The current setting (Off, L1–L3) will
flash.
2. Press
3. Press the PTT button to exit menu or
continue set up.
Note: When using iVOX/VOX, there will be a short delay.
Dual Channel Monitor
Enables you to scan the current channel and another
channel alternately.
To set another channel and start Dual Channel Monitor:
1. Press
/
)
appears. The Dual Channel Monitor icon will flash.
icon appears on the
or
to select the sensitivity level.
Menu until the Dual Channel Monitor icon
Menu to
9
Publicidad
