ACM SPOT PLUS Manual De Instrucciones página 13

TX-FIT SERIES TRANSMITTERS
Using a transmitter of the TX-FIT series you can change the
functions of the control unit that drives the tubular motor.
L1
L1 L2
UP
STOP
DOWN
L1 L2 L3 L4 L5 L6
UP
STOP
DOWN
FAST PROGRAMMING
RAPID TRANSMITTER DATA STORAGE
m
CAUTION: The data storage of the first transmitter
determines the direction of motion of the motor.
m
CAUTION: If the awning has a casing carry out the data
storage of the first remote control by following the procedure
"TRANSMITTER DATA STORAGE"
To store your remote controls on a virgin control unit which
UP
drives a shutter or an awning (WITHOUT casing) proceed as
follows:
1. Supply power only to the control unit to be programmed
STOP
2. Press and hold down the UP+DOWN keys until the motor
starts to move in one direction
3. Release the keys: the motor stops
DOWN
4. Press the UP or DOWN keys according to the direction in
which the roll-up shutter was moving before it stopped:
- if the roll-up shutter was being raised press the UP key;
direction obtained: the UP key raises the roll-up shutter,
the DOWN key lowers the roll-up shutter
- if the roll-up shutter was being lowered press the DOWN
key; direction obtained: the DOWN key lowers the roll-up
shutter, the UP key raises the roll-up shutter.
5. Programming is complete
To add additional remote controls, proceed as follows:
6. Press and hold down the UP+DOWN keys of a remote control
UP
which has already been programmed until the motor starts to
move in one direction
7. Release the keys: the motor stops
STOP
8. Press the UP or DOWN key of the new remote control
DOWN
ACTIVATION OF THE SUN SENSOR ON A
CONTROL UNIT
Press and hold down the STOP+UP keys until the motor confirms
the operation by moving in both directions.
DEACTIVATION OF THE SUN SENSOR ON A
CONTROL UNIT
SUN ON Press and hold down the STOP+DOWN keys until the motor
confirms the operation by moving in both directions.
SUN OFF
C
- 13 -