Publicidad
Idiomas disponibles
Idiomas disponibles
Battery 14V
Carl von Schantz, Managing Director
Signature of issuer
Authorised Representative UK:
Atlas Copco Ltd
Swallowdale Lane
Hemel Hempstead
Hertfordshire HP2 7EA
Regional Requirements
WARNING
This product can expose you to chemicals including lead,
which is known to the State of California to cause cancer
and birth defects or other reproductive harm. For more
information go to
https://www.p65warnings.ca.gov/
Safety
DO NOT DISCARD - GIVE TO USER
WARNING Read all safety warnings, instructions, il-
lustrations and specifications provided with this prod-
uct.
Failure to follow all instructions listed below may result
in electric shock, fire, property damage and/or serious in-
jury.
Save all warnings and instructions for future refer-
ence.
WARNING All locally legislated safety rules regard-
ing installation, operation and maintenance shall be
respected at all times.
Statement of Use
• For professional use only.
• This product and its accessories must not be modified in
any way.
• Do not use this product if it has been damaged.
• If the product data or hazard warning signs on the product
cease to be legible or become detached, replace without
delay.
• The product must only be installed, operated and serviced
by qualified personnel in an industrial environment.
Product Specific Instructions
Operation
General Operation Safety
Read these safety instructions before use.
© Atlas Copco Industrial Technique AB - 9834 5550 00
Operation
• Check the battery pack for damage before every use. Do
not use damaged devices.
• The battery voltage must match the voltage mentioned on
the type plate of the charger and tool.
• Use power tools only with specifically designated battery
packs. Use of any other battery packs may create a risk of
injury and fire.
• Do not incinerate, disassemble or crush the battery pack.
• Avoid contact with fluids oozing out of defective battery
packs. Rinse with water in case of accidental contact with
fluid. Consult a doctor if fluid comes into contact with
eyes.
Charging
• Other chargers than the one stated under Battery
Charger Data are not allowed. Charging the battery on a
not approved charger is considered as altering the system
and will make the tool certification invalid.
• Insert only clean and dry battery packs into the battery
holder of the charger.
• If a protective cover is used on the battery, make sure the
cover is removed and look for potential damage before
charging.
• Check for damage on the battery before charging. Do not
charge any battery pack that has been damaged during
use or by accident (e.g. dents on the housing or any other
damages). Replace damaged battery packs.
• Always remove fully charged batteries from the charger.
Do not let the fully charged battery remain on the
charger.
• Do not operate the charger close to an explosive environ-
ment, for example close to a gas filling station.
• We recommend users to operate the charger in a defined
protected and secure area (e.g. in charging cabinets or un-
der supervision).
• Make sure the charger is stable when charging, to ensure
that the batteries do not fall to the floor.
If you identify noise or extensive heat from a battery:
1.
If charging, unplug the charger. Do not remove the bat-
tery.
2.
Step away from the battery.
3.
Leave the battery for 12 hours.
4.
Contact your Atlas Copco representative.
Storage
• Do not store the battery packs along with metal objects.
No metal parts should come in contact with battery con-
nectors; risk of short circuit.
• Store batteries and chargers in a dry place, and keep dry
at all times.
• Avoid storing batteries fully charged.
• Do not store your battery connected to the power tool for
longer periods
Safety Information
5
Publicidad
