SANDORA XNS032 Instrucciones De Montaje Y De Uso página 3

EN
TECHNISCHE SPEZIFIKATIONEN
Item: Single swing set
Item-No.: 40015
Recommended user age: 3-12 Years
Max. carrying capacity: 50 kg
Max. fall height: 1900 mm
Product dimension: 1630 X 1530 X 2000 mm
Product weight: 12,4 kg
WARNING!
Read the information supplied by the manufacturer. Please read the user manual
included in the packaging to assemble the product. Questions about its safe use
can be answered by calling the dealer or importer of this product.
SAFETY INSTRUCTIONS
Assembly by adults required. Please remove all packaging and packaging attachement
or ties.
• WARNING! Only for domestic use.
• WARNING! Only use under direct supervision of an adult!
• WARNING! Not suitable for children under 36 months. Danger of falling!
• WARNING! Not suitable for children under 36 months. Long cords. Strangulation
hazard.
• WARNING! Choking hazard small parts. Not for children under 3 years.
• WARNING! Suitable for outdoor and indoor use!
• WARNING! Keep away from fire!
• The owners of the swing as well as the competent supervisory personnel are
responsible for ensuring that all users follow the instructions in the operation manual.
• Do not make any technical modifications.
• Changes to the original product must only be carried out according to manufacturer
specifications.
• No one is permitted to gain access to the swing area during use.
• Never stand or kneel on the swing.
• Always hold yourself firmly with both hands.
• No objects of any kind must be in the vicinity of the swing zone (trees, walls,
fences, clotheslines).
• Ensure a safe distance from other structures or obstructions of at least 2 meters
(front and rear) and for a level, shock-absorbing underground (e.g. grass) free
from sharp or pointed objects, obstacles (e.g. clotheslines etc.), gradients, steps,
stairs or hard surfaces (e.g. concrete etc.).
• The lateral distance to stationary parts such as a swing scaffold must at least
amount to 30 cm.
• Swinging components, such as a neighboring swing must be placed at a distance
of at least 60 cm.
• Maximum raised height must not exceed 2.0 meter as measured from the ground.
• The swing must have a minimum distance of 40 cm and a maximum of 60 cm
to the ground when at rest. The swing rope can be lengthened or shortened by
pushing or pulling it through the adjustment loops.
• You should never install a swing in such a way that the user could be blinded
by sun rays.
• The self-locking effect of the self-locking nuts or else lacquer can subside after
repeated loosening and tightening of the connection elements.
• When permanently irradiated with UV light, the material ages significantly faster.
To avoid premature aging and thereby extend the service life, you should always
store the product in a dry and dark place when not in use.
• Do not permanently expose the product to wind, moisture, extreme temperatures
or sunlight.
•
ASSEMBLY INSTRUCTIONS
Before assembly, carefully select and check the location of the swing: Make sure
that the swing support is sufficiently stable. Bear in mind that centrifugal forces
occur when swinging, which can also put a lot of stress on the swing support. Seek
advice from an expert (structural engineer, architect, carpenter) and ask him about
the load-bearing capacity of the swing support. Suspension connections must be
designed so that they cannot be separated unintentionally. After you have taken the
individual parts out of the packaging, please check them for completeness. Follow
steps 1-4 on pages 7-11 for assembly.
SUSPENSION AND ADJUSTABILITY
The suspension points must be at least swing seat width + 100 mm apart. The
swing is supplied with 2 ropes with adjustment eyes so that the swing height can
be variably adjusted to any suitable suspension. The length of the swing rope is
shortened upwards and lengthened downwards by pushing the rope through the
adjustment eyelets. Now the swing can be adjusted individually when suspended.
When adjusting, no one should sit on the swing. When shortening or lengthening
the swing ropes, make sure that the ropes are always the same length. Unequal
rope lengths lead to circular swinging movements of the swing. Adjust the swing
so that the swinging person's toes do not touch the ground. If in doubt, perform a
few light test swings.
MAINTENANCE AND STORAGE
Clean the product only with a cloth or damp cloth and not with special cleaning agents!
Check the product for damage and signs of wear before and after use. Do not make
any structural changes! For your own safety, only use original spare parts. These
can be obtained from E. & G. Groß GmbH. If parts are damaged or sharp corners
and edges have developed, the product must no longer be used!
If in doubt, contact our service department. Store the product in a safe place protected
from the weather so that it cannot be damaged or injure people. In addition, you
should replace all plastic parts after 5 years at the latest to prevent possible failure of
these parts. Check the product before and after use for damage and signs of wear.
Furthermore, we recommend before each use
• Check tightness of nuts and screws, retighten if necessary.
• grease moving parts to minimise wear and tear
• check all covers of screws and sharp edges and replace if necessary
• replace defective parts according to the manufacturer's instructions
• check swing seats, chains, ropes and other accessories for signs of wear and tear
DISPOSAL INSTRUCTIONS
At the end of its service life, please take the unit to the available return and collection
systems. Questions can be answered by the local waste disposal companies.
SERVICE
We endeavour to deliver faultless products. Should faults nevertheless occur, we are
just as anxious to rectify them. Please contact our service department:
+49 7961 9249926
3