Naterial ANEMO ZN DC116 Instrucciones De Montaje, Utilización Y Mantenimiento página 70

FR
3. ELECTRICAL SAFETY
ES
CAUTION: The setup must comply with the NCF 15-100 standard. For your safety, please make
PT
sure that the electric current is switched off before carrying out any setup or connection
operation.
IT
EL
PL
Before connecting the appliance to the power supply, check that the power supply voltage and
UA
current rating corresponds with the power supply details shown on the appliance rating label.
A readily accessible disconnect device must be incorporated in the fixed wiring in compliance
RO
with setup regulations.
Danger of electric shock! Do not attempt to repair the appliance yourself. In case of
EN
malfunction, repairs are to be conducted by qualified personnel only.
If the supply cord is damaged, it must be replaced by the manufacturer, its service agent or
similarly qualified persons in order to avoid a hazard.
For an inspection or maintenance of the electrical parts, the external blind shall be
disconnected from the energy supply in a reliable way.
4. USE
The max. load for non-retractable part: 800Pa.
The actuating member is to be accessible from a height lower than 1.3m
Do not modify the appliance in any way!
Never open the electronic command box (this will void the warranty).
Never use accessories which are not recommended by the manufacturer. They could pose
a safety risk to the user and might damage the appliance. Only use original parts and
accessories. Adapt the fixing to the type of the wall.
Do not use it in places of high temperature such as walls near furnaces (at least -33 °C to 40 °C).
The operation in frosty conditions may damage the wind sensor.
Never use a damaged appliance! Disconnect the appliance from the power supply and contact
your supplier if it is damaged.
Store the transmitter inside the house.
70
What you will need: hardware not provided:
> Waterproof junction box (P54)
> Cables