Publicidad
Idiomas disponibles
Idiomas disponibles
Model: 2147
USING YOUR BLACKSTONE
THE LPG CYLINDER VALVE MUST HAVE:
• Type 1 valve outlet (thread on the outside)�
• Safety relief valve�
• Ul listed overfill Protection device (oPd)� This oPd safety feature is
identified by a unique triangular hand wheel�
• Safety cap (dust cap)�
lPG cylinder valve
lPG cylinder valve
Safety relief
Safety relief
valve
valve
LPG CYLINDER REQUIREMENTS
• The lPG supply cylinder to be used must be constructed and
marked in accordance with the specifications for lP gas cylin-
ders, U�S� department of Transportation (doT) or the Standard for
Cylinders, Spheres and Tubes for the Transportation of dangerous
Goods, CAN/CSA-B339�
• only lPG cylinders marked "propane" shall be used�
The lPG cylinder supply system must be arranged for vapor
withdrawal�
• • Always keep new lPG cylinders in upright position during use, transit or
Always keep new lPG cylinders in upright position during use, transit or
storage.
storage.
• • Always keep the ventilation opening(s) of the cylinder enclosure free and
Always keep the ventilation opening(s) of the cylinder enclosure free and
clear from debris.
clear from debris.
REGULATOR SAFETY
Cross threading can occur if you force thread a connection
at an improper angle. This will damage the threads, lead to
propane leaking, and potentially result in a build-up of fuel
that can ignite.
DO NOT cross thread the connection between your LPG
cylinder and regulator.
If you can not connect the regulator, DO NOT use the
regulator.
Regulator must be replaced with a Blackstone approved
model by a professionally licensed, authorized dealer.
Use this appliance, as purchased, only with gas and regulator/valve
assembly supplied�
FITTINGS & HOSES
• Annual checking and tightening of metal fittings is recommended�
• Keep the fuel supply hose away from any heated surfaces�
• Before each use, check to see if hoses are cut or worn�
Replace damaged hose before using appliance. (Use only Blackstone approved
Replace damaged hose before using appliance. (Use only Blackstone approved
replacement parts for valve, hose, or regulator. Failure to comply will void the
replacement parts for valve, hose, or regulator. Failure to comply will void the
warranty.)
warranty.)
BLACKSTONEPRODUCTS.COM/SUPPORT
oPd hand wheel
oPd hand wheel
Type 1 valve
Type 1 valve
outlet
outlet
Safety cap
Safety cap
WARNING
WARNING
USING YOUR BLACKSTONE
CoNNeCT THe lPG CYlINdeR
20 LB (9 KG)
Turn the control
STEP 01
knobs to oFF�
❶ ❶ ensure that the lPG cylinder
is oFF by turning the oPd hand
wheel clockwise to a full stop�
❷ ❷ Remove the safety cap from
the Type 1 valve outlet�
Hold the regulator in a
STEP 02
straight line with the Type 1 valve
outlet so as not to cross thread
the connection�
Center and insert the regu-
lator nipple into the Type 1
valve outlet�
Hand-tighten the coupling nut in
a clockwise direction�
(do NoT use tools to connect�)
If connection cannot be completed,
If connection cannot be completed,
disconnect regulator and repeat this
disconnect regulator and repeat this
step.
step.
Secure the lPG cylinder
STEP 03
to the appliance by hanging it on
the lPG hook so that it nestles
against the lPG support�
| OWNER'S MANUAL
❶
❶
❷
❷
Coupling nut
Coupling nut
Regulator nipple
Regulator nipple
09
Publicidad
