Sony SRS-D2100 Manual De Instrucciones

Act ive Speaker Syst em
Operating Instructions
Manual de instrucciones
SRS-D2100
© 2004 Sony Corporation
Printed in China
Ow ner's Record
The model number and the serial number are located on the rear of the
subwoofer.
Record the model number and the serial number in the space provided below.
Refer to them whenever you call upon your Sony dealer regarding this product.
Model No. SRS-D2100
Serial No.
Package Cont ent s
Subwoofer (1) Control box (1)
Satellite speaker (2) Base (2)
A
A
Base
,
Screw
Satellite speaker
Attach the base with the
anchor holes facing forward
Attach the base with the
B
anchor holes uppermost
,
Satellite speaker
Screw
Base
Note
First, be sure to apply a bond (anaerobic
threadlocking material) to the hollow wall
anchor to prevent the screw loosening.
5 mm
7 mm
ø 4 mm
Note
9.5 mm or more Do not hang on the satellite speaker or hang
anything on it.
B
Connecting cord
(not supplied)
to INPUT2 jack
Control Box
(rear)
to 8-pin Din jack
Connecting
Cable
(supplied)
Satellite speaker
(rear)
to Front R jack to Front L jack
Subwoofer (rear)
to wall outlet
Downloaded from: https://www.usersmanualguide.com/
3-264-412-11(1)
C
D
Connecting Cable (1)
VOLUM E: Controls total volume level.
BASS: Adjusts bass level (Subwoofer)
PHONE: Connect to headphones for personal listening
Screw (2)
English
Before operating the unit, please read this manual
thoroughly and retain it for future reference.
WARNING
To prevent fire or shock hazard, do not expose the
unit to rain or moisture.
To avoid electrical shock, do not open the cabinet. Refer
servicing to qualified personnel only.
To prevent fire, do not cover the ventilation of the
apparatus with news papers, table-cloths, curtains, etc.
The speaker angle can
Do not place lighted candles on the apparatus.
be changed by
To prevent fire or shock hazard, do not place objects
attaching the base
filled with liquids, such as vases, on the apparatus.
back to front.
Do not install the appliance in a confined space,
such as a bookcase or built-in cabinet.
Anchor holes
CAUTION
Hollow wall anchors
You are cautioned that any changes or modification not
(ø 4 mm, not supplied)
expressly approved in this manual could void your
authority to operate this equipment.
NOTICE FOR THE CUSTOM ERS IN THE USA
40 mm
Precaut ions
On safety
The nameplate indicating operating voltage, power
consumption, etc., is located on the rear exterior.
• Before operating the system, be sure that the
operating voltage of the system is identical with that
to LINE OUT or
of your local power supply.
headphones jack
(stereo mini-jack) CD/MD
Where purchased
Walkman*, etc
U.S.A./Canada
European countries
Other countries
to INPUT1 jack
• The unit is not disconnected from the AC power
source (mains) as long as it is connected to the wall
outlet, even if the unit itself has been turned off.
• Unplug the system from the wall outlet if it is not to
be used for an extended period of time. To disconnect
to LINE OUT or
the cord, pull the cord by grasping the plug. Never
headphones jack
pull the cord itself.
• Should any liquid or solid object fall into the system,
unplug the system's power cord and have the system
PC, etc.
checked by qualified personnel before operating it
any further.
• The AC power cord should be changed only at a
qualified service shop.
• For efficient heat dissipation, ensure there is sufficient
space to the rear of the subwoofer. Also, avoid
placing objects on the unit.
• Do not insert your hand or any objects into the hole of
* "WALKM AN" is a registered
the subwoofer.
trademark of Sony Corporation to
represent Headphone Stereo products.
PC, CD or MD
Walkman, etc.
Subwoofer
Front speaker (Left) Control box
Front speaker (Right)
POWER PHONES
OFF ON
POWER
Control box
PHONE
MIN MAX
VOLUME BASS
VOLUME
On operation
• Do not drive the speaker system with a continuous
wattage exceeding the maximum input power of the
system.
• Before connecting, turn off the speaker system, the
PC and audio component to avoid damaging the
speaker system.
• The volume level should not be turned up to the
point of distortion.
• Although this system is magnetically shielded, do not
leave recorded tapes, watches, personal credit cards
or floppy disks using magnetic coding in front of the
system for an extended period of time.
If the TV picture or monitor display is
magnetically distorted
Although this system is magnetically shielded, there may
be cases that the picture on some TV sets/personal
computers may become magnetically distorted. In such a
case, turn off the power of the TV set/personal computer
once, and after 15 to 30 minutes turn it on again. In the
case of a personal computer, take appropriate measures,
such as data storage, before turning it off.
When there seems to be no improvement, locate the
system farther away from the TV set/personal
computer. Furthermore, be sure not to place objects in
which magnets are attached or used near the TV set/
personal computer, such as audio racks, TV stands, toys
etc. These may cause magnetic distortion to the picture
due to their interaction with the system.
On placement
• Do not set the speakers in an inclined position.
• Do not leave the system in a location near heat
sources, or in a place subject to direct sunlight,
excessive dust, moisture, rain or mechanical shock.
• Do not install the satellite speaker anywhere other
than on a wall.
This symbol is intended to alert the user to
• Do not hang on the satellite speaker or hang anything
the presence of uninsulated "dangerous
voltage" within the product's enclosure on it.
that may be of sufficient magnitude to
constitute a risk of electric shock to persons.
On cleaning
Do not use alcohol, benzene, or thinner to clean the
This symbol is intended to alert the user to
cabinet.
the presence of important operating and
maintenance (servicing) instructions in the
If you have any questions or problems concerning your
literature accompanying the appliance.
speaker system, please consult your nearest Sony
dealer.
Operating voltage
120 V AC, 60 Hz
220 – 230 V AC, 50 Hz
• 110 – 120 V AC, 50/60 Hz
• 220 – 230 V AC, 50 Hz
Inst alling t he sat ellit e speakers Troubleshoot ing
(See fig. A)
Should you encounter a problem with your speaker
system, check the following list and take the indicated
Use the supplied screws to attach the base to the
measures. If the problem persists, consult your nearest
satellite speaker. The satellite speaker can be used either
Sony dealer.
placed on a desk or attached to a wall.
There is no sound from the speaker system.
• Make sure all the connections have been correctly
When you use the satellite speaker on a desk
made.
(See fig. A - A )
• Make sure the VOLUME dial and the each speaker's
By attaching the base to the satellite speaker, it can be
volume dial on the control box.
placed on a desk.
• Make sure the connected component has been turned
up properly.
1
M atch the hole of the base and the
• Check if headphones are connected. If they are,
bottom hole of the satellite speaker.
disconnect them.
Attach the base with the anchor holes facing
The sound is distorted.
forward.
• Turn down the volume level on the connected
The base allows you to adjust the satellite speaker
component. Or, if the connected component has a
to the desired angle.
BASS BOOST function, set it to off.
2
• Rotate BASS on this unit to reduce the bass volume.
Ensure the screw s are tight.
• Turn VOLUME on this unit down to reduce the
Tighten the screw with your finger. If it is difficult,
volume.
use a screwdriver to secure the screw.
There is hum or noise in the speaker output.
• Make sure all the connections have been correctly
When you use the satellite speaker attached
to a w all (See fig. A - B ) made.
• Make sure none of the audio components are
By attaching the base to the satellite speaker, it can be
positioned too close to the TV set.
attached to a wall. Follow the Notes (below) to install
safely. Improper installation may result in the speaker
The sound has suddenly stopped.
falling and causing bodily injury or damage to the
Make sure all the connections have been correctly made.
speaker or other object.
The brightness of the POWER indicator is
1
unstable.
Align the hole in the base w ith the hole
The brightness of the POWER indicator may become
at the rear of the satellite speaker.
unstable when the volume is turned up. This is not a
Attach the base with the anchor holes uppermost.
malfunction.
The base allows you to adjust the satellite speaker
to the desired angle.
2
Specificat ions
Ensure the screw s are tight.
Tighten the screw with your finger. If it is difficult,
use a screwdriver to secure the screw.
Speaker section
3 Satellite speaker
Secure the hollow w all anchor in the w all
Speaker system
— refer to the illustration.
Speaker units
Enclosure type
Notes
Impedance
• Confirm wall thickness is sufficient. A
Cord length
minimum thickness of 9.5 mm is recommended
Subw oofer
for plasterboard.
Speaker system
• Use the specified clamp (hollow wall anchor,
Speaker units
not supplied) when attaching to plasterboard.
Enclosure type
• Refer to the supplied operating instructions Impedance
using a hollow wall anchor.
Amplifier section
• Use wall anchors of at least 20 kg hanging
Rated output
capacity.
• Refer to the instruction supplied with hollow
wall anchor.
• Requires ø 4 mm hollow wall anchor.
Input
• Set up the head of a hollow wall anchor 5 mm
from the wall.
Input impedance
• Apply a bond (anaerobic threadlocking Output
material) to the hollow wall anchor to prevent
General
the screw loosening.
Dimensions (w/h/d)
4
Attach the satellite speaker to the w all.
Insert both wall anchors in the anchor holes of the
satellite speaker base.
Note
Ensure that the satellite speaker is securely
attached to the wall before use.
Mass
Hooking up t he syst em
(See fig. B)
Cord length
1
Connect the cord of the control box to
Power consumptions
the 8-pin Din jack of the subw oofer w ith
their respective arrow s aligned.
Supplied accessories
Connecting Cable
2
Connect the satellite speakers to the
Optional accessories
subw oofer.
Connecting cord RK-G136, RK-G138
Confirm the location of the satellite speakers, and
Plug adaptor PC-236MS
then connect to their respective jacks.
Design and specifications are subject to change without
3
Connect the control box to the source
notice.
equipment.
– PC, etc.:
Connect the INPUT1 jacks of the control box and
the LINE OUT or headphones jack of a PC, etc.
with the supplied connecting cord. For details,
refer to the operating instructions of the PC.
– CD/ M D Walkman, etc.:
Connect the INPUT2 jack of the control box and
the LINE OUT or headphones jack of a CD/MD
Walkman, etc. The connecting cord is not supplied
with this system.
Note
To switch INPUT1 and INPUT2, use ON/OFF of
the device connected to the control box.
4
Connect the subw oofer to the w all
outlet.
5
Position the speakers. (See fig. C )
List ening t o t he sound
(See fig. D)
First, turn down the volume on the control box. The
volume should be set to minimum before you begin
playing the programme source.
1
Set the POWER sw itch to ON on the
control box.
The POWER indicator lights up.
2
Adjust the VOLUM E control on the
control box.
You can adjust the volume of the subwoofer and
each satellite speaker.
When connecting to the headphone output, also
adjust the volume of the connected component.
After listening, set the POWER switch to OFF.
The POWER indicator goes off.
3
Using headphones/ earphones.
Connect headphones/earphones to the PHONES
jack on the control box.
Note
Turn off the MEGA BASS or BASS BOOST
(Walkman, etc.) function as it may cause audible
distortion.
Full range, magnetically shielded
5.6 cm, cone type
Closed type
6 Ω
3 m
Woofer
16 cm, cone type
Bass reflex
6 Ω
12 W (10% T.H.D., 1 kHz, 6 Ω)
(Satellite speaker)
80 W (10% T.H.D., 100 Hz, 6 Ω)
(Subwoofer)
Stereo mini jack × 1 (INPUT 1)
Stereo mini jack × 1 (INPUT 2)
4.7 kΩ (at 1 kHz)
Stereo mini jack × 1 (PHONES)
Approx. 130 × 40 × 73 mm
(5 1 / × 1 5 / × 2 7 / in.) (Control box)
8 8 8
Approx. 95 × 135 × 150 mm
× 5 × 6 in.) (Satellite speaker,
(3 3 / 3 /
4 8
on a desk)
Approx. 95 × 100 × 180 mm
(3 / × 4 × 7 / in.) (Satellite speaker,
3 1
4 8
attached to a wall)
Approx. 285 × 285 × 462 mm
(11 1 / × 11 1 / × 18 1 / in.)
4 4 4
(Subwoofer)
Approx. 200 g (7 oz.) (Control box)
Approx. 490 g (1 lb. 1 oz.)
(Satellite speaker)
Approx. 8.2 kg (18 lb. 1 oz.)
(Subwoofer)
2 m (Control box to subwoofer)
2 m (Power cord)
31 W