Publicidad
Idiomas disponibles
Idiomas disponibles
•
Connect the operating pedal(s) to the appropriate inlets.
•
Set the knobs to the appropriate angle of bending for a given step.
Set the power switch to the "I" position.
•
Insert a piece of rod and press the button to start the bending or press the
•
pedal (in the case of the MSW-RC-250D whatever is appropriate for a
given step - the second step is not operated by the bending button!)
NOTE: in the event of any problem or emergency, press the red
Emergency Stop button. The movable bending roller will return to its
original position.
3.4.
Cleaning and maintenance
a)
Pull the mains plug and let the unit cool down completely before cleaning,
adjusting or replacing accessories and when the unit is not in use.
b)
Use only non-corrosive cleaning agents for cleaning the surfaces.
c)
After each cleaning, all the parts should be dried well before the unit is used
again.
d)
Store the unit in a dry and cool place protected from moisture and direct
sunlight.
e)
Do not spray the unit with a stream of water or immerse it in water.
f)
Make sure that no water enters through the ventilation openings in the casing.
g)
Clean the ventilation openings with a brush and compressed air.
h)
Perform regular inspections of the unit checking technical fitness and any
damages.
Publicidad
