LUND 67590 Manual De Instrucciones página 13

GB
and lead to electric shock. It is forbidden to drill any holes in the product, as well as making
any other modifi cations of the product not described in the manual. Move the product only
when cooled down, grasping the bottom of the housing. Do not move the product by grasp-
ing the bowl holder. Do not move the product by pulling the power cord. The temperature at
the place of installation and use of the product must be within the range of +10 C ÷ +38 C,
O O
and the relative humidity must be below 90% without water vapour condensation.
Recommendations for connecting the product to the power supply
Before connecting the product to the power supply, make sure that the voltage, frequency
and performance of the power supply correspond to the values shown on the product's rating
plate. The plug must fi t into the socket. It is forbidden to modify the plug or socket in any man-
ner to make them fi t. The product must be connected directly to a single socket of the power
supply. NEVER use extension cords, adapters or double outlets. The mains circuit must be
equipped with a protective cable and at least 16 A protection. Avoid contact between the
power cord and sharp edges and hot objects and surfaces. During operation, the power cord
must always be fully extended and the position of the power cord must be set so that it does
not become an obstacle during product operation. The power cord should not be placed in
a manner which would pose a risk of tripping. The power supply socket should be located in
a place where it is always possible to quickly remove the product power cord plug. Always
pull the power cord by the plug housing when unplugging it, never by the cord. If the power
cord or the plug is damaged, immediately disconnect it from the power supply and contact
an authorised service centre of the manufacturer for replacement. Do not use the product
with a damaged power cord or plug. The power cord or plug cannot be repaired and must be
replaced with a new one that is free of defects if these components are damaged.
Instructions for use
WARNING! All accessories placed inside the appliance and the housing of the appliance
can be hot after use. Do not touch them, as it may cause severe burns. Allow the tool com-
ponents to cool down. If you need to move these components before they cool down, hold
them by the handles provided for this purpose. Use heat protection gloves. Make sure that
the fl oor near the place of use of the product is not slippery. This will prevent slipping, which
can cause serious injuries. Due to the holes in the accessories, special care should be taken
when handling hot accessories. Liquids produced during the heat treatment of food may leak
through the holes. Contact with hot liquids can lead to severe burns. The product may only
be connected to the power supply during operation. When fi nished, pull out the power plug
to disconnect the appliance from the power supply. Do not leave the product connected to
the power supply unattended. Always place the drip tray at the bottom of the fryer chamber.
This will reduce the risk of liquid entering the enclosure and also facilitate cleaning the interior
of the appliance. Foodstuff s placed in the bowl must not protrude over the edge of the bowl.
Do not use accessories other than those supplied with the product or authorised by the man-
ufacturer. All accessories included are designed in such a way that they do not interfere with
the air circulation inside the appliance. Observe the product at all times during food prepara-
tion. Food left unattended can burn, which can cause fi re and serious burns. The bowl and
O R I G I N A L I N S T R U C T I O N S
13