Descargar Imprimir esta página

Grohe Ondus 36 084 Manual De Instalación página 5

Publicidad

Idiomas disponibles

Idiomas disponibles

Connect faucet, see figs. [8] and [9].
The cold water supply must be connected on the right,
hot water supply on the left.
Open hot and cold water supply and check connections
for leakage.
Operation
Using the operating panel
Start/Stop button
Starts and stops the faucet at a preset temperature
(factory setting 100 °F) and full flow rate.
Pause button
Interrupts the flow of water. The flow is resumed
by pressing the button again.
The faucet switches off automatically after a preset
time (factory setting 60 sec.).
Temperature
Increases (red arrow, left) or decreases (blue arrow,
right) the water temperature.
Volume
Increases
or decreases the flow rate in four
stages in total.
Define start temperature
Press and hold the button for 10 seconds
=> 3 water pulses
Adjust until optimum temperature is reached
=> 3 water pulses
English
Maintenance
Inspect and clean all components and replace if necessary.
Disconnect voltage supply.
Shut off hot and cold water supply.
Disconnect all plug-in connectors, see fig. [9].
I. Battery, see Fig. [10].
The battery must be replaced 10 years after commissioning
the fitting, at the latest.
II.Thermistor, see Fig. [11].
1. Disconnect plug-in connector (A).
2. Unscrew nut (B) and pull out thermistor (C).
III. Flow control (48 009), see fold-out page I.
Install in reverse order.
Replacement parts
See fold-out page I (* = special accessories).
Disposal note
Dispose of batteries in accordance with national
regulations.
2

Publicidad

loading