TCL M Serie Manual De Instrucciones página 10

Troubleshooting
Having trouble completing installation? Don't worry, it's usually an easy fix.
PROBLEM
Dehumidifier does
not start
Dehumidifier does not dry the
air as it should
POSSIBLE CAUSES
The dehumidifier is unplugged.
The fuse is blown/circuit breaker
is tripped
Dehumidifier has reached its
pre-set level or the bucket is full
Bucket is not in the proper position
Power failure
Not enough time allowed for unit to
remove moisture
Airflow is restricted
Dirty filter
The Humidity Control may not be set
low enough
Doors and windows may not be closed
tightly
Clothes dryer may be blowing moist
air into the room
Room temperature is too low
• Make sure the dehumidifier plug is pushed
completely into the outlet.
• Check the house fuse/circuit breaker box
and replace the fuse or reset the breaker.
• The dehumidifier automatically turns off
when either condition occurs. Change to
a lower setting or empty the water bucket.
The bucket must be replaced properly for
the dehumidifier to operate.
• The bucket must be in place and securely
inserted for the dehumidifier to operate.
• There is a protective time delay (up to 3
min.) to prevent tripping of the compressor
overload. For this reason, the unit may not
start normal dehumidification for 3 min.
after it is powered back on.
• When first installed, allow at least 24 hours
to reach the desired dryness/humidity level.
• Make sure there are no curtains,
blinds , or furniture blocking the front
or back of the dehumidifier.
• Clean the filter. See the Cleaning
and Care Section of the manual.
• For drier air, press the v button to lower
the humidity setting percentage in the room
set the dehumidifier to CO for maximum
dehumidification.
• Check that all doors, windows, and other
openings are securely closed.
• Install the dehumidifier away from the
dryer. The dryer should be vented outside.
• Moisture removal is best at higher room
temperatures. Lower room temperatures
will reduce the moisture removal rate.
This model is designed to operate at
temperatures above 41° F (5°C).
10
SOLUTIONS