Ferax AT-280 Manual página 22

• Interruption of work should be ensured or another kind of work, not involving use
of vibrating tools should be alternatively performed, in order to reduce the harmful
influence caused by the vibration.o Ensure that the workplace is well lit.
Tools must be lubricated
Before use always lubricate the tool with a few drops of oil AIRTOIL 22 (Luna 15531-
0105) intended for use with pneumatic tools by dropping it into the air inlet opening of
the tool. In case of continuous work, a pneumatic lubrication system (Luna 20571-0106)
should be used, adjusted to about two drops per minute.
If the tool is not used for a longer period of time, it is required to drop a few drops of oil
before storage of the tool, in order to reduce the corrosion risk.
Attention! Use only oil that is supposed for pneumatic tools specified in the operation
instructions. Use of other oils may result in "clumping" of oil and reduction of the
movement ability of the machine. It may cause reduced work efficiency.
Leakages must be avoided
Avoid leakages in the air circulation system. Always use a thread sealing tape at the
point where the pipe is connected to the tool. Pay attention that hoses and hose fastening
clamps are in good working order.
The compressed air must be dry
As clean and dry the compressed air is, the longer is lifetime of the tool. In order to
ensure that, we recommend use of air filter, which removes water from the compressed
air and reduce risk of damages on tool and connections caused by corrosion.
Remember to remove eventual water condensate from the compressor and the
compressed air supply system before each working day.
Important information
21