FF Europe ELKESS-A-100L Manual De Instrucciones página 19

EN
SECURITY CHARACTERISTICS
The max inlet pressure is 0.8Mpa.
● Following warning sentences:
If the supply cord is damaged it must be replaced by the manufacturerer, its service agent
or similarly qualified persons in order to avoid a hazard.
● The pressure-relief device is to be operated regularly to remove lime deposits and to
verify that is not blocked
● CAUTION: In order to avoid a hazard due to iadvertent resetting of the thermal cut-out,
this appliance must be not supplied through an external switching device, such as a timer,
or connected to a ciruit that is regularly switched on and off by the utility.
● This appliance can be used by children aged from 8 years and above and persons with
reduced physic sensory or mental capabilities or lack of experience and knowledge if they
have been given supervision instruction concerning use of the appliance in a sate way and
understand the hazard involved. Children shall not play with the appliance, cleaning and
users maintenance shall not made by children without supervision.
● This electrical water heater must be installed with a mono-directional safety vale at the
inlet pipe (blue indicator) when the tank's pressure is over 0.8MPa. This will automatically
activate the safety valve. Water will exit at the drain pipe outlet (Diagram 1). In any con-
dition, this outlet must not be blocked.
If there is a need to empty the water in the tank, first close the mains water. Remove the
fixed screw nail on the safety valve. Lift up the plastic handle (see Diagram 2) to let the
water flow out naturally.
MAINTENANCE
● All maintenance operation must be carried out by a qualified personnel.
● Before contacting the customer service, make sure the suspected failure is not caused
by a temporary lack of water.
● To discharge the water completely from the tank, remove the safety valve from the wa-
ter heater. Before removing the valve, the power of the heater needs to be switched off
for the tank to cool down (outlet connection must also be disconnected).
19