FF Europe ELKESS-A-100L Manual De Instrucciones página 24

EN
● This electrical water heater should be mounted on a solid cement wall, preferably
where it is close to the power source's sockets and water source.
● Please use our company's fitted accessories to mount this electric water heater.
● Before determining the bolt hole's position, you should ensure that the heater is more
than 200mm from the ground or ceiling board. This will leave space for maintenance when
necessary.
● Assembling method: After selecting the proper fixing positions, use the inflating bolt to
secure the naging board firmly, then hook the electric water heater.
Inflation Bolt
Firm Cement Wall
PIPE CONNECTION
● All piping parts are BSP 1/2". Wind some white tape at the thread sector of the inlet pipe
(marked blue).
● Fix the safety valve to the inlet pipe and then connect it to the cold water pipe of the
mains.
● Install a water drainpipe to the safety valve to drain away water discharge. (drain pipe
joint outlet - diagram 5).
● Install the drainpipe in a continuously downward direction and in a frost free environ-
ment.
● Connect the hot water pipe (market red) to the outlet pipe.
● Do not over-tighten the safety valve and all pipes joint as it may cause damage to he
joints.
● Make sure all pipes are clean before installing the taps and showers.
24