Ferroli RIMINI DP 500 Instrucciones Para La Instalación Y El Uso página 57

RIMINI DP
Choose the location of the thermal emitter following the minimum distances indicated below:
Note: If the windowsill protrudes less than 20 mm, the gap above the emitter could be disre-
garded.
3. ELECTRICAL CONNECTION
The electric thermal emitter must be connected to the mains supply (230 V ~ 50 Hz) through its
plug. The maximum permissible impedance of the mains at the connection point will be:
In addition, the following warnings must be considered:
- The device must not be located underneath an electrical outlet or switch.
- The power line should be protected with a high-sensitivity differential device.
4. MOUNTING
The thermal emitter must be held by its handles, as shown in the following image:
A73021553
Z = 0.16 Ω
max
EN
57