Publicidad
Idiomas disponibles
Idiomas disponibles
3. Secure the vertical support to the mounting assembly using a carriage bolt (710-0276)
and a wing knob (720-04122) from hardware pack (689-02364). Refer to Figure 5 on
page 6.
NOTE: Some kits may contain cross-mount brackets with numerical identification over the
holes instead of letters as shown. If this is the case, use the hole corresponding to the deck
size the bagger is being installed on.
INSTALL HANGER ASSEMBLY
1. Install (1) and secure (2) the hanger assembly (683-04498B) to the vertical support using
two carriage bolts (710-0276), two cup washers (736-0242) and two lock nuts (712-
04063) from hardware pack (689-02364). Do not overtighten. See Figure 6.
1
ASSEMBLING REMAINING BAGGER COMPONENTS
1. Snap the upper chute support (731-17091A) in place by first clipping the side portion onto
the hanger assembly rail (1). See Figure 7.
2
2. Snap the front side of the upper chute support to the rail (2), as shown in Figure 7.
3. Attach the bagger deflector (731-27134) to the upper chute support using the three
screws (710-05108) supplied in deflector hardware pack (689-02299). See Figure 8.
4. If not previously installed by the factory, install the screen (731-06504) into the bagger
cover (631-04298) by first inserting the end closest to the center into the cutout mounting
hole, as in Figure 9.
2
2
Figure 6
1
Figure 7
Figure 8
Figure 9
SET-UP
NOTE: Make sure to feed the screen under the lip, as in Figure 10.
Make sure screen sits under the cover's lip
5. Clip in the other side by flexing the screen and pushing it down into the provided cutout
hole. See Figure 10.
6. Install the bagger cover onto the hanger assembly, as seen in Figure 11. The plastic cover
goes inside of the two mounting tabs.
Cover mounts in between
these two tabs
7. Slide the hinge pin (711-05079) into the hole located on the mounting tab, as in Figure 12.
Use the cut-out window (see inset in Figure 12) to line up the hinge pin on the other side
and push pin all the way in until it reaches the end-stop. At this point the pin clips into
place and is secured by a tab in the bagger cover. See Figure 13.
7
Figure 10
Figure 11
Figure 12
Figure 13
Publicidad
