Publicidad
Idiomas disponibles
Idiomas disponibles
wall: See image 03 on page 4.
Please note that the product must be
installed at least 15 cm from the floor and
50 cm from the ceiling.
If you wish to wall mount the unit, please
consider the following installation notes:
7. Uninstall the body support, as shown
in image 07.
8. Drill the holes on each side of the
wall and insert the expansion plugs.
Secure the bracket to the wall with
the screws as shown in image 08.
9. Place the device in the appropriate
position so that the holes are aligned
with the bracket, As shown in image
09.
10.
Tighten the screws on the top of
the bracket to make it firm, As shown
in image 10.
USING THE APPLIANCE
Before using for the first time, check when
you are unpacking the appliance that is
not damaged.
Insert the plug into a suitable socket outlet
on an A.C. power supply having the same
voltage as that shown in the product label.
The touch screen buttons located on the
product correspond to the remote control
functions:
To learn more about the product; the screen
and the LED display, see image 04 on page
5.
LED display
11. Power indicator light
12. Power indicator light
13. Wi-Fi
14.
Temperature control
15. Timer
16. Child lock
Control panel
17. "+" temperature button
18. "-" temperature button
19. Power on button
20.
Mode button
21. Timer button
22.
Child lock button
To learn more about the remote control of
the product, see image 05 on page 5.
Remote control
23.
Power on button
24.
Mode button
25.
Temperature
26.
Timer
27.
Child lock
Power function
Before you working the heater,your should
turn on the switch in side.
Press "
" to set functions. The upper part
of the display shows the room temperature,
and the heater will operate on default
values.
Mode
Press "
" to regulate the temperature to
a higher or lower power, if you use a low
power it will take longer to achieve the
selected temperature, otherwise it will take
shorter.
Temperature selection
Press "+" or "-" button to select the desired
temperature from a range of 5°-40°C. The
temperature indicator will remain lit for a
long time.
Timer
Press the timer button "
desired range between 1 hour to 24 hours.
he remaining time will appear.
Child clock
Press the child clock botton 3 seconds,"
" will be display on the screen,so you
can not make any operate beside"
same ways to touch to delete the child
clock function.
EN
", to select the
",and
25
Publicidad
