Garmin EDGE 1040 Guia De Inicio Rapido página 9

The Garmin logos on the module and
the strap should be right-side up.
2 Wet the electrodes
patches on the back of the strap to
create a strong connection between
your chest and the transmitter.
3 Wrap the strap around your chest, and
connect the strap hook
.
NOTE: The care tag should not fold
over.
The Garmin logos should be right-side
up.
4 Bring the device within 3 m (10 ft.) of
the heart rate monitor.
After you put on the heart rate monitor, it
is active and sending data.
Installing the Cadence Sensor
NOTE: If you do not have this sensor, you
can skip this task.
Quick Start Manual
TIP: Garmin recommends you secure
your bike on a stand while installing the
sensor.
1 Select the band size that fits your
crank arm
The band you select should be the
smallest one that stretches across
the crank arm.
and the contact
2 On the non-drive side, place and hold
the flat side of the cadence sensor on
the inside of the crank arm.
3 Pull the bands
arm, and attach them to the hooks
on the sensor.
to the loop
4 Rotate the crank arm to check for
clearance.
securely.
around the crank
9