Santoemma POWERTEC Manual De Uso Y Mantenimiento página 15

The model Powertec is a machine for professional use. The warranty has a duration of one
year and regards all the faults due to manufacturing defects. The faults due to improper use
are not covered by warranty.
For a good preservation of your machine, do the following:
1. After using the machine, before storing it, remove all the water from the 2 tanks. Put then
some liters of water inside the solution tank and drain it completely by letting the pump
work and keeping the spray lever pressed. This operation is useful to clean the hydraulic
circuit of the machine, including the pump, the couplings, the nozzle.
2. Periodically clean the water filter, removing it from the machine and rinsing it under
water.
3. Periodically check and clean the filter of the vacuum motor, which is located between the
2 tanks.
4. Eliminate the lime that, in the long run, deposits in the hydraulic circuit, by putting a
special anti-lime chemical in the solution tank and letting it work from some hours. Use
the same products used for dishwashers. Empty and then rinse the solution tank. This
operation should be done every 6-8 months.
5. Periodically bring the machine to a technical service point, to check the correct working of
all the parts subject to wear. In particular: pump and vacuum motor. There are some
parts, like carbon brushes, bearings, and so on, which must be replaced on time to avoid
serious damages to the components upon which they are assembled. These damages
cannot be then covered by warranty. This check should be done every 500 working
hours.
Maintenance
15