Car and Driver CAD-FMX500 Manual De Usuario página 6

Mounting
You can mount your CAD-FMX500 with either of these methods:
Method 1: Vent mounting
1. Turn the mounting nut counter clockwise to loosen the clamp.
2. Insert the ball knob with clip and clip button into the clamp on the charger
base, and turn the nut clockwise to tighten the ball knob.
3. Press the Clip button to open the clip to fix on the air vent window of your
car. You can turn the ball knob to adjust your desired angel for the phone
mount.
4. Press the Release button on the upper right of the phone mount to unlock
the adjustable gripper (side).
5. Place your phone onto the charging pad, and adjust the two adjustable
grippers (both sides) to lock your phone in place.
Clip button
Mounting nut
Clip
Ball knob
Clamp
Method 2: Dash mounting
1. Turn the mounting nut counter clockwise to loosen the clamp.
2. Insert the dash mount with suction cup into the clamp on the phone
mount, and turn the nut clockwise to tighten the ball knob.
EN 5