Car and Driver CAD-FMX500 Manual De Usuario página 8

Bluetooth Mode
To play the music from your phone, you need to pair your phone with the
device. When pairing for the first time, follow the steps below:
1. Make sure the device is powered on.
2. Open your phone's Bluetooth settings.
3. Search "CAD-FMX500" from your bluetooth list, and tap it to connect.
4. Three seconds after connected, the display will return to FM status.
5. Turn on the car's radio, and choose an unoccupied radio station. Then
push the FM wheel on the device for one second until the LED display
flashes the frequency.
6. Turn the button up/down to match the same frequency. Once done, you
can play the music from your phone. Use the "play/pause button to play or
pause the music.
Note: This device has auto power-off memory function, which means it will
remain the same FM frequency the next time it turns on, so you do not need
to match the frequency again unless you change it on either your car's radio
or this device during previous use.
1. For Phone Call mode
If someone calls you while you're playing music, this device will automati-
cally switch to telephone mode.
Answer/End a call
Reject a call
Redial a call
2. For Aux mode
When you use the aux cable, you can play the music from your phone
without matching the device's FM frequency the same as the car's.
Plug one end of the aux cable into the AUX OUT port of your phone mount,
and the other end into the car's radio aux port. Then press the "Mode
Switch" button until the LED display will show the word "AUH" to indicate
the aux status. You are now ready to enjoy your music.
Press the Play/Pause button
Press and hold the Play/Pause button
Press the Play/Pause button
EN 7
once
for two seconds
twice