Car and Driver CAD-FMX500 Manual De Usuario página 7

3. Remove the protective film from the adhesive suction cup on the bottom
of the mount. Then press the suction cup onto your dashboard and push the
lock down to secure it in place. Adjust the CAD-FMX500's angle and height
so that it does not block your view of the road, and tighten the knob to secure
it in place.
4. Press the Release button on the upper right of the phone mount to unlock
the adjustable gripper (side).
5. Place your phone onto the charging pad, and adjust the two adjustable
grippers (both sides) to lock your phone in place.
Powering on
To power on this device, c
cable to the CAD-FMX500's Type C port, and the other end to the
supplied car power adapter. Plug the Car power adapter into your
car's DC power outlet.
LED display. Then after 2 seconds, the word "bt" will flash on the display of
this device for pairing.
To your car's DC
power outlet
Lock Open
onnect one end of the supplied USB - Type C
Once turned on, the word "HI" will appear on the
EN 6
Tighten Knob
Lock Closed