Craftsman 580.328310 Instrucciones De Uso página 7

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

Check
Battery
t Attach
Negative
Battery
Wire
The sealed battery on the generator is fully charged
and pre-installed
except for the negative (black)
battery cable.
You will need two 8mm wrenches to install the
negative battery cable.
To install:
.
Negative
Battery Cable
3.
Slide negative battery cable over screw on
negative terminal.
4.
Reattach washer and nut and tighten.
5.
Verify that connections to battery and generator
are tight and secure.
Cut off tie wrap securing loose end of negative
(black) cable.
Remove nut and washer on negative battery terminal.
BEFORE
STARTING
"THE
NOTE: Synthetic oil meeting JLSAC GF-2, APJ
certification mark and APJ service symbol with "SJ/CF
ENERGY CONSERVING" or higher, is an acceptable
oil at all temperatures.
Use of synthetic oil does not
alter required oil change intervals.
* The use of multi-viscosity oils (5W-30, 10W-30, etc.)
in temperatures above 40°F (4°C) will result in higher
than normal oil consumption. When using a multi°
viscosity oil, check oil more frequently.
** If using SAE 30 oil in temperatures below 40°F
(4°C), it will result in hard starting and possible engine
bore damage due to inadequate lubrication.
2.
Place generator on a level surface.
3.
Clean area around yellow oil fill cap and dipstick.
Remove dipstick and wipe with clean cloth.
4.
Push dipstick back in and remove to check oil level.
5.
Remove oil fill cap and slowly fill engine with oil
through the oil fill opening. Fill to "Full" mark on
dipstick.
6.
Install yellow oil fill cap and finger tighten securely.
7.
Check engine oil level before starting each time
thereafter. If oil level is below "Full" mark on
dipstick, fill to "Full" mark on dipstick.
Add Engine
Oim
NOTE: When adding oil to the engine crankcase, use
only high quality detergent oil rated with API service
classification SF, SG, SH, SJ or higher. DO NOT use
speciaJ additives.
1.
Choose a viscosity according to the following tame:
STARTING
TEMPERATURE
RANGE
ANTICIPATED
BEFORE
NEXT
OiL CHANGE

Publicidad

Tabla de contenido
loading

Tabla de contenido