Grundig MGK 9030 Manual De Instrucciones página 43

5 Operation
• Only cut a small amount the first
time you use it. This is the only
way to get used to the variable
positions.
• Keep combing the hair. Only look
for hair which is too long and
comb out clippings.
5.2 Beard trimming
Please use the beard trimming at-
tachment (12) or (1).
1. If necessary,
attachment by holding the head
and pushed away from the
appliance.
2. Insert beard
attachment (12) or cutting hea
(1) d carefully at the top and
press down until it clicks into
place.
3. Loosen the beard hair by
combing the beard in the
direction the hair grows.
4. Press the button (3) to switch on
the appliance and start trimming
your beard.
5. Press the button (3) to switch off
the appliance after use.
Multi Grooming Kit with Charging Dock / User Manual
remove the
trimming
5.3 Trimming hair or
beard to a certain length
Use accessories 7-8-9 for hair
and 14 for beard.
1. If necessary,
attachment by holding the head
and pushed away from the
appliance.
2. Insert attachment (1) or (14)
carefully at the top and press
down until it clicks into place.
3. Push the comb attachment
carefully and firmly onto the
rounded rear half of the cutting
head from above and let it click
into place. The attachment
combs (7), (8) and (9) are
compatible with the cutting
head (1).
To adjust the small
and large adjustable
C
comb attachments
7, 8 and 9 press the
middle of each at-
tachment and push
it up or down.
remove the
43 / EN