MaxPro MPBMS255L Manual Del Usuario página 5

M M itre Saw MPBMS255L User Manual
power supply authority
4.Always disconnect plug from power source before making any adjustment or changing any accessory
5.This tool should not be used by people under the age of 16 years
6.This tool is not suitable for wet cutting
OUTDOOR USE
When used outdoors, connect the tool via a fault current (FI) circuit breaker with a triggering current of 30
mA maximum, and only use an extension cord which is intended for outdoor use and equipped with a
splashproof coupling-socket
BEFORE USE
1.Always check that the supply voltage is the same as the voltage indicated on the nameplate of the tool
2.Use completely unrolled and safe extension cords with a capacity of 16 Amps (U.K. 13 Amps)
3.Always mount the tool on a flat and stable working surface (e.g. workbench)
4.Wear protective glasses, hearing protection, and protective gloves
5.Dust from material such as paint containing lead, some wood species, minerals and metal may be
harmful (contact with or inhalation of the dust may cause allergic reactions and/or respiratory diseases to
the operator or bystanders); wear a dust mask and work with a dust extraction device when connectable
6.Certain kinds of dust are classified as carcinogenic (such as oak and beech dust) especially in conjunction
with additives for wood conditioning; wear a dust mask and work with a dust extraction device when
connectable
7.Follow the dust-related national requirements for the materials you want to work with
8.Do not work materials containing asbestos (asbestos is considered carcinogenic)
9.Never use the tool without the original protection guard system
10.Check the protective guard for proper closing before each use
11.Do not operate the saw if the protective guard does not move freely and close instantly
12.Never clamp or tie the protective guard into the open position
13.Always firmly clamp the workpiece (do not work with pieces that are too small to clamp)
14.Always support the free ends of a long workpiece
15.Never allow another person to hold or support the workpiece while working; use the saw table
extension
16.Never use the tool without the table insert; replace a defective or worn table insert
17.Remove all obstacles on top of as well as underneath the cutting path before you start cutting
18.Avoid damage that can be caused by screws, nails and other elements in your workpiece; remove them
before you start working.
ACCESSORIES
1.Never use grinding/cutting discs with this tool 18
2.MAXPRO can assure flawless functioning of the tool only when the correct accessories are used which
can be obtained from your MAXPRO dealer
3.For mounting/using non-MAXPRO accessories observe the instructions of the manufacturer concerned
4.Use only accessories with an allowable speed matching at least the highest no-load speed of the tool
5.Never use saw blades made of high speed steel (HSS)
6.Do not use a saw blade which is cracked, deformed or dull
7.Only use saw blades with a hole diameter which fits the tool spindle without play; never use reducors or
adaptors to fit large-hole saw blades
8.Protect accessories from impact, shock and grease
DURING USE
1.Do not force the tool; apply light and continuous pressure
2.Keep fingers, hands and arms away from the rotating saw blade
3
3.Push spindle-lock button only when tool is at a standstill
4.When slotting, ensure that the saw blade does not get jammed in the workpiece
5.If the saw blade becomes blocked, switch off the tool immediately and disconnect the plug; only then
5