Ryobi RYRM8006 Guía De Armado página 4

 Remove the Philips head screws from the top perimeter
of the crate on all for sides. Carefully lift the crate lid up
and set aside.
NOTE: Two people are required for this lift.
 Remove the Philips head screws from the bottom side
board of the crate. Remove the Philips screws from each
upright on both sides of the panel.
NOTE: Two people are required for this step.
 Carefully remove the crate wall and set aside.
NOTE: Two people are required for this lift.
 Repeat for the remaining three sides.
NOTE: Two people are required for this steps.
 Remove bag and side discharge shoot packing.
 Remove the seat, remove seat packaging.
 Carefully cut the straps securing your front and rear wheel
axles to the crate.
WARNING:
If any parts on the Loose Parts List are already assem-
bled to your product when you unpack it, verify the part
is assembled correctly, is properly tightened, and is
torqued correctly (where applicable) before proceeding
to the next assembly step. Use of a product that may
have been improperly assembled could result in death
or serious personal injury.
 Inspect the product carefully to make sure no breakage
or damage occurred during shipping.
 If any parts are damaged or missing, please call
1-800-525-2579 for assistance.
NOTE: Mower should be assembled while positioned on
the frame bottom.
1.
UNPACKING
2.
3.
2X
4.
4 — English
2X
2X