Publicidad
Idiomas disponibles
Idiomas disponibles
4
1
2
3
5
6
7
8
OPERATING INSTRUCTIONS: WET VACUUMING
The vacuum can be used for wet pick up with or without the use of the squeegee nozzle.
For use with the squeegee nozzle:
1. Verify that the switch is in the OFF position before plugging in (Fig. 1).
2. Fit the squeegee nozzle into the nozzle opening on the container (Fig. 2).
3. Insert the plug into the 12V power socket (Fig. 3).
NOTICE: Vehicle will typically need to be in 'ACCESSORY' mode in order for power to be supplied to
the socket.
4. Turn the motor on by sliding the switch to the ON position and begin vacuuming (Fig. 4).
5. After use, turn the vacuum off and disconnect the plug from the 12V power socket (Fig. 5)..
6. Remove squeegee nozzle from the nozzle opening and clean it (Fig. 6).
7. Empty the container, clean and dry the inside and outside before storage (Fig. 7 & 8).
9
IMPORTANT!
The vacuum is designed for vacuuming only small amounts of liquid.
STOP vacuuming if the liquid in the container reaches the "max" indicator line on the container (Fig. 9).
Empty it immediately before next use or storage.
8
Publicidad
