Tritec TRI-Xi 1.8 Manual De Instalación página 9

2. Installation and Set-up
2
Illustration 2.4: Mounting
Illustration 2.5: Removal
8
Mounting
Slide the inverter upwards until the inverter
snaps into the wall bracket top slots, and low-
er the inverter until it rests in the wall bracket
slots (1). Push the bottom end of the inverter
against the wall until the lock spring snaps in
place (2). Check that the inverter is now se-
curely fixed to the wall bracket.
Removal
Insert a screwdriver or similar into the wall
bracket side slot. Move the screwdriver up-
wards while pulling the inverter away from the
wall until the lock spring disengages (1). Pull
the inverter bottom end away from the wall
(2). Slide the inverter upwards until it disen-
gages from the wall bracket and remove it
from the wall (3).
L00410352-02