Publicidad
Idiomas disponibles
Idiomas disponibles
Edge
Press
from 1 to 65535.
Level
See
CAN trigger
The Controller Area Network (CAN) trigger allows triggering on CAN version 2.0A
and 2.0B signals. The basic CAN trigger will trigger on the Start of Frame (SOF)
bit of a Data frame. A CAN message frame in the CAN_L signal type is shown
below:
Source
See
Signal
Press
also automatically sets the channel label for the source channel that can be
connected as follows:
– CAN_H – actual CAN_H differential bus signal.
Dominant low signals:
– CAN_L – actual CAN_L differential bus signal.
– Rx – Receive signal from the CAN bus transceiver.
– Tx – Transmit signal from the CAN bus transceiver.
– Differential – CAN differential bus signals connected to an analog source
Keysight U1610/20A User's Guide
>
"Level"
on page 55.
"Source"
on page 55.
repeatedly to set the type and polarity of the CAN signal. This
channel using a differential probe.
Using the Oscilloscope
and use the
or
key to set the edge count
3
59
Publicidad
