Publicidad
Idiomas disponibles
Idiomas disponibles
3
Using the Oscilloscope
Automatic Measurements
You can perform up to 30 automatic measurements (time, voltage, and power) on
any channel source or running math function.
To make a quick measurement:
1 Press
2 Press
3 Press
4 Press
Last four
measurement
results
Figure 3-9
Cursors are turned on to show the portion of the waveform being measured for the
most recently selected measurement.
If a portion of the waveform required for a measurement is not displayed or does
not display enough resolution to make the measurement, the result will be
displayed as no signal, no edges, greater than a value, or less than a value.
68
to access the measurement function menu.
repeatedly to select a channel or math source. The math
source is applicable only when
and use the
Press
again to exit the selection menu.
to make the selected measurement.
Measurement function menu
Analyzer Controls
are enabled.
keys to select a measurement type.
Keysight U1610/20A User's Guide
Publicidad
