Palram CANOPIA ANCHORING KIT Instrucciones De Montaje página 5

EN INFORMATION
SAFETY ADVICE
It is of utmost importance to assemble all of the parts according to the directions.
• •
Do not skip any steps.
Always wear work gloves during panel sliding.
• •
Always wear shoes and safety goggles when working with extruded aluminium.
• •
If using a step ladder or power tools make sure that you follow the manufacturer's
• •
safety advice.
Do not touch overhead power cables with the aluminium profiles.
• •
Do not attempt to assemble the product in windy or wet conditions.
• •
Do not climb or stand on the roof.
• •
Dispose of all plastic bags. Keep them out of reach of small children.
• •
Keep children away from the assembly area.
• •
Do not lean against or push the products during construction.
• •
Do not position your product in an area exposed to excessive winds.
• •
Do not attempt to assemble this product if you are tired, have taken drugs or alcohol or if you
• •
are prone to dizzy spells.
Hot items such as recently used grills, blowtorches etc. must not be stored in the product.
• •
Make sure there are no hidden pipes or cables in the ground before anchoring to foundation.
• •
Make sure to anchor the product directly to a solid foundation to increase the product's
• •
stability and wind resistance in areas with severe weather conditions.
Make sure that there are no obstructions between the assembly area and the final position
of the product.
CARE & MAINTENANCE
When your product needs to be cleaned, use a mild detergent solution and rinse with cold
• •
clean water.
DO NOT use acetone, abrasive cleaners or other special detergents to clean the panels.
• •
Clean the product once assembly is complete.
• •
BEFORE ASSEMBLY
Selecting a site:
• •
- Choose your site carefully before beginning assembly.
- Choose a sunny position away from overhanging trees.
- The product must be positioned and fixed on a flat level surface.
The product must be secured directly to a solid foundation.
• •
This is a multi-part assembly best achieved by two people. Allow at least half a day
• •
for the assembly process.
Take all components & parts out of the packages. Sort the parts and check against
• •
the content parts list.
Parts should be laid out close at hand. Keep all small parts (screws etc.)
• •
in a bowl so they do not get lost.
Please note multi-sided profiles are used in this product. As a result some holes in the
• •
profiles are not used during assembly.
Please review entire instructions before starting. Carry out the assembly steps in exact order.
• •
Please consult your local authorities if any permits are required prior to constructing
• •
the product.
IMPORTANT!
Firmly connect the product to a level surface immediately after completion of the assembly.
• •
Anchoring this product to the ground is essential to its stability and rigidity.
• •
It is required to complete this stage in order for your warranty to be valid.
During assembly use a soft surface below the parts to avoid scratches and damages.
• •