Publicidad
Idiomas disponibles
Idiomas disponibles
ENGLISH
2.
Use the UP and DOWN buttons to highlight the desired RF
channel. Then press SELECT.
3.
When the RF channel is selected, the following message appears
on the remote display screen:
Set slide switch on J-Box PCB to the LEARN MODE.
Red LED
4.
At the Transceiver J-Box, remove the cover to expose the PCB.
5.
Slide the learn switch to ON.
6.
On the handheld remote display screen, a prompt will read:
Restore J-Box Slide Switch and Press J-Box Reset Button.
7.
Slide the learn switch inside the transceiver J-Box to OFF.
8.
Press the reset button inside the transceiver J-Box.
9.
When complete the red and green LEDs on the J-Box will blink
simultaneously.
Page 12
Jandy
AquaLink
®
®
Transceiver J-Box - Internal View
Green LED
(Receive)
(Send)
D3
D2
Reset
Button
Wireless Handheld Remote | Installation & Operation Manual
RESET
MAIN CONNECTOR
G
Y
B
R
PCB
Publicidad
