Pur Line CHE-220 Manual De Usuario página 12

OPERATION
CONTROL PANEL
5
First, turn on the power switch in the back of the device , then you can start the function operation on control
panel.
1. FLAME EFFECT: Set the ON/OFF switch to the ON position to turn on the flame effect without any function
of the heater.
2. LOW POWER HEATING: Set the ON/OFF switch to the ON position and the "I" switch to the ON position.
3. HIGH POWER HEATING: Set the ON/OFF switch to the ON position and the "I" and "I I" switches to the ON
position.
4. THERMOSTAT: After the fireplace has been turned on and the room has reached the desired temperature,
slowly slide the thermostat knob (4) to the left until the heater turns off (a slight "click" should be heard). By
leaving the thermostat on the setting it will automatically maintain this temperature. To lower the temperature,
slide the thermostat knob to the left. To increase the temperature, slide the thermostat knob to the right.
5. FLAME BRIGHTNESS: Slide the flame knob (5) to the left or to right direction to adjust the flame brightness.
ASSEMBLY OF THE LEGS:
Simple assembly is required if the legs of your electric
fireplace arrive unassembled.
Using a screwdriver, drive three screws through the holes
in each leg, and tighten them counterclockwise on the
underside of the appliance.
Please note that additional screws are supplied, you may
have some left over after assembly.
3
II
max
min
EN
2 1
I ON/OFF
10
4
max
min