Johnson JCRL120P2 Manual De Usuario página 48

3. INSTALLATION METHOD
4. Wire controller upper part Remove
Insert a flat screwdriver into the

slots in the lower part of the wire
controller (2 places).
 Remove the upper part of the wire
controller (Fig.3-4)
NOTE: The PCB is mounted in the
upper part of the wired controller. Be
careful not to damage the board with
the screwdriver.
5. Fasten the wire controller back plate
 For surface mounting, fasten the back plate on the
wall with the 3 screws (M4x20) and plugs. (Fig.3-5)
Screws (M4×20)
Back plate
Fig 3-5
8
Slots
Fig 3-4
V.1