Accessmatic Scorpion 901 Manual De Usuario página 18

901
Opening your life
7. Programming the operator
7.1 Preparing
7.1.1 Keep trolley locked, pull and push the door by hand, make sure the trolley connects with the shuttle-
7.1.2 Turn on the power, the courtesy light is on for several seconds, at the same time, the LED displays the number from 99
to 11. Then the operator turns to standby situation.
7.1.3 At last, it displays "- -".
7.2 Settings open and close positions
7.2.1 Press and hold "SET" until it displays "P1".
7.2.2 Press "SET" it displays "OP".
7.2.3 Then press and hold "UP", it ashes "OP".
7.2.4 When the door has reached the open position, press "SET", it displays "CL".
7.2.5 Then press and hold "DOWN", it ashes "CL". When the door has reached the closed position, press "SET".
7.2.6 The door opens and closes automatically to map the open and close sensitivity force requirements.
7.2.7 It displays "- -" to show setting is complete.
7.3 Self learning transmitter
7.3.1 When the unit has stored 20 codes, it ashes "Fu", or preventing coding mistakes, it is necessary to cancel all the stored
codes.
7.3.2 Press and hold "CODE", it displays "SU".
7.3.3 Hold more than 8 seconds, it ashes "dL", all the codes were cancelled.
7.4 Adding or changing transmitters
7.4.1 Press "CODE", it displays "Su".
7.4.2 Press a button on the transmitter, then release and press the same button again, "Su" ashes.
7.4.3 Then it displays "- -" to show settings is complete. Repeat up steps to code a maximum of 20 di erent transmitters
and/or buttons.
7.5 Force adjustments
7.5.1 Press and hold "SET", it displays "P1".
7.5.2 Press "UP" once, it displays "p2".
7.5.3 Press "SET" once again, it will show the current situation. Press "UP" to increase the force one degree or press "DOWN" to
decrease one degree. Maximum degree is "F9", minimum is "F1".
7.5.4 Press "SET" to con rm. The default settings is "F5".
7.5.5 After nishing all the settings, please check the force to make safe.
7.6 Photo beam
7.6.1 Press and hold "SET", it displays "P1".
7.6.2 Press "UP" twice, it displays "P3".
7.3.3 Press "SET" to show current situation. Press "UP" once it displays ""H1, the photo beam is enabled. Press down once, it
displays "H0", the photo beam is disabled. Press "SET" to con rm and quit.
7.4.4 If you do not use the photo beam device, please make sure it displays "H0", to close this function.
1 4