Publicidad
Idiomas disponibles
Idiomas disponibles
901
Opening your life
7.7 Auto – close ON/OFF
7.7.1 Press and hold "SET", it displays "P1".
7.7.2 Press "UP" three times, it displays "P4".
7.7.3 Press "SET" to show current situation. Press "UP" to increase the auto – close one minute or press "DOWN" to decrease
one minute. Maximum degree is "b9", minimum is "b0". Press "SET" to con rm.
7.7.4 The default settings is "b0", "b0" shows auto – close o . This function works when the door reaches the open positions.
7.8 Lock door
7.8.1 Press and hold "SET", it displays "P1".
7.8.2 Press "UP" four times, it displays "P5".
7.8.3 Press "SET" to show current situation. Press "UP", displays "Lc", lock door functions works or press "DOWN", it displays "uL",
lock door functions doesn´t work. Press "SET" to con rm the function you need.
7.8.4 When you use uncovered transmitters, it is recommended using lock door function. This function works when the door
reaches the closed positions, you can´t open the door until press the "unlock" button rst.
8. Owner´s guide
8.1 Attention in use
8.1.1 At the rst time of using the door, please test the driving system to see if it moves well. (Test method: unlock the trolley,
pull and push the door by hand).
8.1.2 Connected with the appropriate power and socket by professionals, and connected the earthing wire with earth.
8.1.3 Using the transmitters in your sight. Do not stand ok walk under a moving door. The transmitters should be out of
reaching of children.
8.1.4 Make sure the door out o
re, moisture, electromagnetism and some other places.
8.1.5 Check at least twice a year to make sure the door is properly balanced and that all working condition. Adjust the tensile
force of chain. Add suitable amount of lubricant to the active.
8.2 Examination guide
8.2.1 Problem Causes Solution
8.2.2 The chain is noisy.
The chain in too loose.
Adjust nut-M8 referring to 3.2.C.
8.2.3 The motor does not work.
The socket is not well connect or the fuse is broken.
Check the socket or replace the fuse.
8.2.4 After setting open and close positions, the motor does not work.
The screw of xing the hail components are loose or program mistakes.
Tighten the screw or resetting open and close positions.
8.2.5 The door can´t be closed.
Photo beam functions works.
Cancel the photo beam function, referring to 6.6.
5
Publicidad
