Publicidad
Idiomas disponibles
Idiomas disponibles
Setting Upper and Lower Limits / Learning a New Preset Position
1. Press and release the (Up, Down, or Preset) button that will be programmed. (Shade will move to selected position.)
2. Press and hold the same (Up, Down, or Preset) button until the shade jogs.
3. Tug the shade 6-10 inches. The shade will jog in response.
4. Adjust shade to desired position. (Manually roll shade by hand if necessary.)
5. Press and hold the same (Up, Down, or Preset) button. (Shade will jog when learned.)
IMPORTANT
The Lower Limit Position must be set prior to using the preset positions (20%, 40%, 60%, 80%). These
positions are based on the Lower Limit Position of the shade. When learning new positions, the button
currently being programmed (after Step 2 of Setting Upper and Lower Limits) will not move the shade. After
Step 5 all buttons resume full functionality.
Example 1: When learning a new Upper Limit Position, the Up button is semi-disabled. Only by pressing
the Up button 3 times will the shade move to the up position (or manually roll the shade up by hand).
Example 2: When learning a new Lower Limit Position, the Down button is disabled. The shade can still be
adjusted using the Up button (or manually roll the shade by hand).
Delete / Unlearn a Channel from the Shade
(Shade at Upper Limit)
1. Press and release the CH button until the channel currently paired to the shade is selected. (Skip channel selection for single-
Channel Remotes.)
2. Use a paper clip to press the Program button on back of the remote. (The channel LEDs will scroll back and forth.)
3. Press and hold the UP button until Shade moves downward
4. Tug the shade 6-10 inches The shade will jog in response.
5. Use a paperclip to PRESS the PROGRAM button again. The channel LEDs will scroll back and forth.
6. Press the Down button,. The shade will jog, move to Upper Limit Position, then jog again.
Master Reset
This will delete all remotes from controlling the shade.
1. Start with the shade at the upper limit position. Manually roll shade up by hand if necessary.
2. Use a paperclip to press the Program button on back of the remote. The channel LEDs will scroll back and forth.
3. Press and hold the Down button until the shade moves downward and jogs.
4. Tug the shade 6-10 inches. The shade will JOG in response.
Replacing the Battery in the Remote
Remove the rear housing of the QdR2. Use a U.S. Quarter coin or similar.
Insert the quarter into the slot and twist to separate the back from the front.
Repeat this process around the QdR2 until the snaps release and the rear
housing is fully separated from the front housing.
Replace the battery with a CR2032 battery. Install the battery with negative
polarity side facing towards the QdR2 circuit board.
When complete, snap the back onto the front.
2
80%
60%
40%
20%
CH
1 3
2 4 5
+
C R 2 0 3 2
3 v
Publicidad
