Publicidad
Idiomas disponibles
Idiomas disponibles
SYM-
SIGNAL
BOL
CAUTION
CAUTION
6
PROPOSITION 65
WARNING
This product contains a chemical known to the
state of California to cause cancer, birth defects
or other reproductive harm. Some dust created by
power sanding, sawing, grinding, drilling, and other
construction activities contains chemicals known to
cause cancer, birth defects or other reproductive
harm. Some examples of these chemicals are:
•
Lead from lead-based paints;
•
Crystalline silica from bricks and cement and other
masonry products;
•
Arsenic and chromium from chemically treated
lumber.
Your risk of exposure to these chemicals varies
depending on how often you do this type of work. To
reduce your exposure to these chemicals, work in a
well-ventilated area, and work with approved safety
equipment, such as dust masks that are specially
designed to filter out microscopic particles.
Save these instructions.
7
INSTALLATION
7.1
UNPACK THE MACHINE
WARNING
Make sure that you correctly assemble the machine
before use.
WARNING
•
If parts of the machine are damaged, do not use
the machine.
•
If you do not have all the parts, do not operate the
machine.
•
If parts are damaged or missing, contact the
service center.
1. Open the package.
2. Read the documentation provided in the box.
English
MEANING
Indicates a potentially haz-
ardous situation, which, if
not avoided, may result in
minor or moderate injury.
(Without Safety Alert Sym-
bol) Indicates a situation
that may result in property
damage.
3. Remove all the unassembled parts from the box.
4. Remove the machine from the box.
5. Discard the box and packing material in compliance
with local regulations.
WARNING
For your personal safety, do not insert battery before
the tool is assembled completely.
7.2
INSTALL THE BLADE
Before you install the blade, remove the battery pack
from the machine.
1. Turn the blade release clamp in the direction of
arrow and hold.
2. At the same time, push the blade to the deepest
position.
3. Release the blade release clamp.
Make sure that the blade is tightened. When cutting
wet wood, please clean up the dust and debris near
the blade clamp in time.
7.3
REMOVE THE BLADE
1. Turn the blade release clamp in the direction of
arrow and hold.
2. At the same time, pull the blade out.
3. Release the blade release clamp.
7.4
INSTALL THE BATTERY PACK
7
NOTE
NOTE
EN
Publicidad
