Anker PAP 22 Manual De Instrucciones página 4

Declaration of Conformity
Hereby, Anker Innovations Limited declares that this product is in
compliance with Directives 2014/53/EU & 2011/65/EU. The full text of the
EU declaration of conformity is available at the following internet address:
https://www.anker.com
GB Declaration of Conformity
Hereby, Anker Innovations Limited declares that this product is in
compliance with Radio Equipment Regulations 2017 & The Restriction of the
Use of Certain Hazardous Substances in Electrical and Electronic Equipment
Regulations 2012. The full text of the GB declaration of conformity is
available at the following internet address: https://www.anker.com
Anker Innovations Limited
Room 1318-19, Hollywood Plaza, 610 Nathan Road, Mongkok, Kowloon, Hong
Kong
The following importers are the responsible parties (contracts for EU and
UK matters):
Anker Technology (UK) Ltd
GNR8, 49 Clarendon Road, Watford, Hertfordshire, WD17 1HP, United
Kingdom
Anker Innovations Deutschland GmbH
Georg-Muche-Strasse 3, 80807 Munich, Germany
This symbol indicates that this product shall not be treated as
household waste. Instead it shall be handed over to the applicable
collection point for the recycling of electrical and electronic
equipment.
(a) frequency band(s) in which the radio equipment operates;
(b) maximum radio-frequency power transmitted in the frequency band(s) in
which the radio equipment operates.
Radiated H-Field -13.50 dBμA/m@10m
TX/RX frequency range 111-205KHz
03 EN
FCC Statement
This device complies with Part 15 of the FCC Rules. Operation is subject
to the following two conditions: (1) This device may not cause harmful
interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation.
Warning: Changes or modifications not expressly approved by the party
responsible for compliance could void the user's authority to operate the
equipment.
Note: This equipment has been tested and found to comply with the limits
for a Class B digital device, pursuant to Part 15 of the FCC Rules. These
limits are designed to provide reasonable protection against harmful
interference in a residential installation.
This equipment generates, uses, and can radiate radio frequency energy
and, if not installed and used in accordance with the instructions, may
cause harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation. If this
equipment does cause harmful interference to radio or television reception,
which can be determined by turning the equipment off and on, the user is
encouraged to try to correct the interference by one or more of the following
measures:
(1) Reorient or relocate the receiving antenna.
(2) Increase the separation between the equipment and receiver.
(3) Connect the equipment to an outlet on a circuit different from the
connected receiver.
(4) Consult a dealer or an experienced radio / TV technician for help.
FCC RF exposure statement:
This equipment complies with FCC Radiation exposure limits set forth for an
uncontrolled environment. This equipment can be used in portable exposure
condition without restriction.
EN 04