YATO YT-82456 Manual De Instrucciones página 12

GB
CAL – temperature calibration
It is recommended to perform temperature calibrations before fi rst use and from time to time. Set the temperature to 350 C and
O
wait for the tip to heat. Clean the tip with a damp sponge and then coat with a tin layer to facilitate conductivity. Read the measured
temperature, then press and hold the knob for about 6 seconds to enter the temperature calibration mode. In this mode, enter the
measured temperature with the knob and confi rm the selection. Temperature calibration is completed.
REST – settings deletion
Press and hold the knob for approx. 9 seconds to enter the settings deletion mode. Use the knob to select YES to delete the
settings or NO not to delete the settings. Press the knob to confi rm the selection and exit the settings deletion mode.
USB port
The USB port located on the front of the station is intended for supplying electrical devices which use the USB standard. They can
be used, for example, to charge mobile phones that can be charged from a USB port.
MAINTENANCE AND STORAGE
After fi nishing work, clean the tip using a damp sponge and then place the soldering iron in the stand, switch off the soldering
station with the power switch and leave it until all elements have cooled down completely. Disconnect the station from the power
supply by pulling the power cord plug out of the power socket. Clean the station housing and soldering iron holder with a soft cloth
slightly dampened with water, then dry it.
Check the tip condition; if any defects, damage, or changes in shape are observed, replace the tip with a new one. Unscrew the
clamping sleeve by rotating the ring located near the soldering iron handle. Then pull out of the sleeve the old tip and replace it
with a new one. Mount the sleeve with the tip to the soldering iron.
The sponge for cleaning the tip should be cleaned under a jet of lukewarm water. Replace excessively soiled or damaged sponges
with new ones.
Store the product disconnected from the power supply in places not accessible to unauthorised persons, especially children. The
storage place should protect against dust, moisture, precipitation, excessive heat, and provide adequate ventilation to prevent
condensation of water vapour.
O R I G I N A L I N S T R U C T I O N S
12