cozze 90514 Manual De Usuario página 38

CONNECTING THE GAS CYLINDER TO THE APPLIANCE
This appliance is only suitable for use with low-pressure butane or propane gas and fitted
with the appropriate low-pressure regulator via a flexible hose. The hose should be secured
to the regulator and the appliance with hose clips/nuts. This plancha is set to operate a 28
mbar regulator with butane gas, and a 37mbar regulator with propane gas, and a regulator
with butane/propane mixture at 37mbar, and a regulator with butane/propane mixture at
50mbar and a regulator with butane/propane mixture at 30mbar. Use a suitable regulator
cer tified to BSEN 16129: 2013. Please consult your LPG dealer for information regarding a
suitable regulator for the gas cylinder.
TO CHECK FOR LEAKS
Make 2-3 fluid ounces of leak detecting solution by mixing one part washing up liquid with 3
parts water.
Ensure the control valve is "OFF".
Connect the regulator to the cylinder and ON/OFF valve to the burner, ensure the
connections are secure then turn ON the gas.
Brush the soapy solution on to the hose and all joints. If bubbles appear you have a leak,
which must be rectified before use.
Retest after fixing the fault. Turn OFF the gas at the cylinder after testing.
If detected leakage can not be rectified, do not attempt to cure leakage but consult your gas
dealer.
In the event of gas leakage, turn off the gas supply.
REGULATOR AND HOSE
Use only regulators and hose approved for LPG at the above pressures (See the technical
form). The life expectancy of the regulator is estimated as 10 years. It is recommended that
the regulator is changed within 10 years of the date of manufacture.
The use of the wrong regulator or hose is unsafe; always check that you have the correct
items before operating the plancha.
The hose used must conform to the relevant standard for the country of use. The length of
the hose must be 1.5 meters (maximum). Worn or damaged hose must be replaced. Ensure
that the hose is not obstructed, kinked, or in contact with any part of the plancha other than
at its connection.
The hose should comply with the standard EN16436.
The hose should not be twisted or kinked when attached to the gas cylinder.
Flexible metal or rubber pipe, used to connect the appliance with the LPG cylinder must be
changed within the prescribed intervals and according to the National Rules in force.
No part of the hose should touch any part of the appliance.
38