Publicidad
Idiomas disponibles
Idiomas disponibles
SLEEP TIMER
The sleep timer lets you decide how long you want to listen to a radio station of your choice before falling
asleep.
1. In FM radio mode, repeatedly press
10-minute increments.
The display will show the set sleep time and symbol
2. The radio will be turned off after the set sleep time has elapsed.
To check remaining sleep time, press
To turn off the radio before the sleep time has elapsed, repeatedly press
disappears from the display.
SETTING THE BRIGHTNESS OF THE DISPLAY
Repeatedly press
conditions.
USING THE PROJECTOR
The projector function allows you to display the time on a nearby wall or ceiling. The projected time can
be best viewed at a dark room at a maximum distance of 3 metres.
1. Press
2. Adjust the projector to change the angle of rotation at which the time appears.
Do not stare into the lens directly.
3. To turn off the projector, press
TROUBLESHOOTING
No sound / power.
Increase the volume by repeatedly pres s
Check that the unit is plugged in.
Check that the unit is not in standby state. Press
Radio reception is poor.
Fully extend the wire aerial to get the best reception and sound quality.
Retune for radio stations, refer to Listening to the Radio.
Try moving your clock radio to another location to see if reception improves.
Check that you do not have other electrical equipment too close to your clock radio, causing
interference.
to change the brightness of the display according to your ambient light
to turn on the projector.
to set the desired sleep time from 10 to 90 minutes in
.
.
.
.
until the symbol
to turn on the unit.
EN-7
Publicidad
