Publicidad
Idiomas disponibles
Idiomas disponibles
Machine does not start.
Machine pressure is
not consistent.
Machine stops
automatically.
The end of the draw
hose will not stay
submerged.
Machine does not draw
any water after long
time storage.
20
2 in 1: Portable Power Cleaner/
Water Sprayer
The battery pack is not attached
well.
Battery pack charge has been
depleted.
Defective battery.
Additional air could be sucked into
the machine.
It is at low pressure setting.
Battery pack charge has been
depleted.
The multi-spray nozzle is blocked.
The current protection is activated.
There is air remaining in the
draw hose and/or the float is not
adjusted properly.
Additional air could be sucked into
the machine.
Reinstall the battery pack.
Replace with a new battery pack or recharge the
battery pack.
Replace with a new battery pack.
Check connection between the hose adapter
and the draw hose.
No action need.
Replace with a new battery pack or recharge the
battery pack.
Remove the multi-spray nozzle and turn on the
machine. If the machine works normally, replace
with a new multi-spray nozzle.
Ensure all air is removed from draw hose.
Adjust float location on draw hose to allow filter
to sit well below water's surface, yet just above
water source's bottom where filter may quickly
fill with debris.
1) Hold the Hydroshot lower to the ground (less
than 5' off of the ground) to improve water flow.
2) "Pre-fill the draw-hose" completely with water
to ensure all air is removed.
3) Operate the hydroshot without the lance or
nozzle attached to allow a higher volume of
water to quickly and easily flow throw the unit.
Once all air pockets appear to be removed,
reinstall the lance and nozzle.
4) Connect directly to a water spigot with garden
hose to clear all air from the system. Refer to
figures E1, E2, E3.
EN
Publicidad
