Danfoss RET1001M Guia De Instalacion página 4

Installation Guide
1 . Installation Steps
EN
1 . Installation must be done by an authorised
electrician .
2 . The room thermostat should be installed at approx .
1 .5 m above floor and where the effects of sunlight,
draught or other heat sources (eg . TV's) are avoided,
see fig . 1 . on page 44 .
3 . First loosen lower retaining screws and carefully
remove back plate, see fig . 2 on page 44 .
4 . Mount back plate direct to wall or on wall box and
wire according to application, see fig . 3 on page 44 &
fig . 5 on page 45 according to application .
5 . Locate hooks at top of front part into top of back
plate and lower into position and tighten retaining
screws .
2 . Dimensions and Wiring
See fig . 4 for dimensions and fig . 5 for wiring diagram
on page 45 .
3 . LED indicators
Power on - Green
Thermostat Output on - Red
4
RET1001M Room Thermostat
VISUM14F Danfoss Heating Solutions